Plot Comments This track unit was much better suited to this application compared to the tires that were tested on Unit E21. From a load carrying and soil compaction, the track system out performed tires for this load. […]
Plot Comments This Unit compared a bias ply tire and a VF tire on the center section of a central fill corn planter. Note that the tire pressures for this unit are similar and in fact the VF tire was inflated to a higher pressure which is not what would be expected. To carry the load on the bias ply […]
Plot Comments This Unit shows how imbalance duals can be misleading. The plots E20_A_ 3 show the high peak for the single tire but when compared to the outer dual in plots E20_B_3 the stress is substantially reduced. Notice that the weight being carried by the outer dual is very low compared to the inner […]
Plot Comments This Unit had a high load on very narrow tires with high pressure. The plots show the variability in pressure across the face of the tread as it was difficult to consistently hit the sensor with the center of the tire. […]
Plot Comments Unfortunately data for the load picture was not obtained. However, notice that the truck loads the soil on the front tires more than the rear in the empty condition. The rear peak would have been slightly higher if the loaded test was collected. Also note that a lot of the stress is measured in the 6 […]
Plot Comments This set of plots shows the baler tires only. The last two peaks of each plot show the baler tire response. These tires are well balanced and equally loaded. However notice the increase in soil pressure in the center of the face of the tire. The pressure is reduced when measured about 1/3 […]
Plot Comments This Unit was equipped with a central tire inflation system (CTIS). This is a good example of high and low pressure tires. The load on the soil is reduce for the 6 inch depth when the tire pressure is reduced. The load at the 12 inch and 20 inch depth is not reduced by […]
This combine is a good example of a bias tire versus a VF radial tire. For both sensor locations 1 and 2, the bias ply tire (E11_L_1 and E11_L_2) exerted a higher force on the soil than the VF tire (E11_R_1 and E11_R_2). The rear tires in both test were measured approximately the same giving good […]
Plot Comments This unit is a good example of a combine set up. The IF and VF tires are allowing for a much lower tire pressure than one might normally expect on a combine. Overall the small footprint of these tires may mean that the stress is not as small as one would expect with a low tire […]
Plot Comments This combine with tracks was tested on the second installation only. The plot titled E9_2 was measured down the center of the track face, between the sets of rollers. The plot titled E9_offset_2 was the same track aligned with the outside set of rollers over the center. There stress in at the 6 inch depth is increased under […]
Plot Comments The combination is a tracked grain cart with a similar weight to Unit E7. The track unit on this machine appears much better suited to carrying this amount of weigh. The configuration would be substantially safer that a single tire for carrying this amount of weight. The outside dual on the tractor was almost in […]
Plot Comments This vehicle has the same radial tire that was seen on Unit E6. The plot E7_1 shows the left side and an overall larger response due in part to a more wet soil profile. The plot E7_2 shows the left side again with a similar response to the same tire on Unit E6 The soil pressure […]
Plot Comments Similar results to other CTIS systems. Comparing the high pressure tires to the low pressure tires shows reduction of stress at 6 and 12 inches. The heavy weight still creates high stress at 20 inches regardless of pressure. […]